Books
Permanent URI for this communityhttp://197.211.34.35:4000/handle/123456789/3
Books
Browse
5 results
Search Results
Item Effect of Steel Fibre Reinforcement on the compressive strength of Natural Aggregate Concrete(Proceedings of the Nigerian Society of Engineers 2023 National Engineering Conference, Exhibition and Annual General Meeting, 2023-01-03) Malachi, G.; Kolo, D. N.; Abbass, B. A.Item Production of Pavement Blocks Using Low Density Polyethylene Product Waste(Proceedings of the 4th International Conference (SETIC), School of Environmental Technology, Federal University of Technology, Minna, Nigeria, 2023-01-02) Aboje, A. A.; Abbas, B. A.; Kolo, D. N.; Abubakar, M.; Abdulsalam A. M.Waste sachet water packs cause considerable land pollution in Nigeria. In this research, pavement block was produced using low density polyethylene products waste (sachet water packs) as an alternative binder. The production was achieved by first converting the sachet water packs into pellets and blending it with sandstone in a mass ratio of 8:2 (A), 7:3 (B) and 6:4 (C) sandstone to pellets respectively. The compressive strength, %water absorption and curing time tests were carried out on the pavement block to determine it suitability and safety for low-traffic use. The compressive strength for polymer concrete samples A, B and C were 13.65N/mm2 , 16.99N/mm2 and 20.34N/mm2 respectively. After carrying out the %water absorption test on the polymer concrete A, B and C the following result was obtained: 8.33%, 5.47% and 4.03% respectively. It should be noted that the polymer concrete samples and the control samples which (are cement concrete based) are for light-traffic use (pedestrian, plazas, shopping complexes ramps, car parks, office drive ways, rural roads with low traffic, and residential road).Item Reliability Studies on Reinforced Concrete Column Subjected to Axial Load with Natural Stone as Coarse Aggregate(Nnamdi Azikiwe University Journal of Civil Engineering (NAUJCVE), 2024-01-02) Kolo, D. N.; Aguwa, J. I.; Abubakar, M.This paper presents the reliability assessment of a reinforced concrete column subjected to Axial loading. Locally available natural aggregate (NA) was used in concrete production, the results of preliminary tests revealed the aggregate was adequate for concrete production. A typical column cross section of 230 × 240 × 3000mm was adopted and probabilistically assessed. First Order Reliability Method (FORM) was employed to estimate the implied probabilities of failures. The results of the sensitivity analysis showed that the reinforced concrete column is structurally safe at length, breadth and depth of 3200, 240 and 230 mm with Probability of Failures of 1.14 ×10-3, 8.45 × 10-4 and 8.45 × 10-4 respectively.Item Reducing Concrete's Permeability through the use of Crystal-X as an additive mixture.(Bani Waleed University Journal of Human and Applied Sciences, 2024-11-02) Ateig, N. S.; Milad, A. M. L.; Musbah, A. A.; Kolo, D. N.The permeability of concrete refers to its capacity to allow the passage of water and moisture. Permeability plays a crucial role in various aspects, including preserving the longevity and visual appeal of structures, as well as minimizing issues related to leakage and deterioration. Several methods have been devised to enhance the permeability of concrete, and one such method involves incorporating chemical crystals called Crystal-X. These materials improve the concrete's hydrophobic properties, reducing the likelihood of water leakage. Crystal-X possesses the capacity to absorb water that is found within the pores of the concrete and transform it into crystals that are not soluble. When the pores become saturated with these crystals, they create a barrier that prevents water and moisture from entering. The outcomes of multiple laboratory tests performed on both fresh and hardened concrete were elucidated and clarified subsequent to the incorporation of Crystal-X as an additive, at dosages ranging from 0.9% to 1.3% of the weight of the cement. The concrete's workability was assessed through a slump test, while its hardened state was evaluated through tests measuring compressive strength, permeability, and absorption rate. After a curing period of 28 days, the addition of Crystal-X at a rate of 1.3 % by weight of cement resulted in a 15.93% increase in the compressive strength of the concrete. Similarly, the permeability of the concrete decreased by 11.9% when Crystal-X was added at the same rate.Item Environmental Effects of Road Construction Waste(. USEP: Journal of Research Information in Civil Engineering, 2023-02-12) Kolo, S. S.; Abdulrahman, H. S.; Kolo, D. N.; Shehu, M.; Adamu, H. N.,; Eze, F. E.This research work investigates the various waste streams generated during road construction and their effect on environment. The method employed in this research work is categorized into waste type generated on construction site using reconnaissance surveys, data collection and data analysis methods. Four construction project sites in Minna, Nigeria, were used with the aim that these sites will provide a platform to acquire valuable data. It was discovered that mortar or concrete waste and wood waste has the highest percentage of 22% to 39% and asphalt has about 4 % waste and this was largest percentage of waste generated and this was mainly due to the human error, the use of inadequately trained and unskilled labour. The study however made case for adequate attention and concentration towards improving effective waste management by implementing proper waste management and disposal systems and encouraging the use of recycled materials in road construction. This will greatly reduce the cost of construction, increase efficiency, reduce work time and replenish the earths rapidly depleting natural resources used in construction like wood and bitumen.