Civil Engineering
Permanent URI for this collectionhttp://197.211.34.35:4000/handle/123456789/148
Civil Engineering
Browse
Item ASSESSMENT OF THE PROPERTIES OF HIGH STRENGTH CONCRETE MADE USING QUARRY DUST AS FINE AGGREGATE(1st International Civil Engineering Conference (ICEC 2018), 2018-09-22) Mohammed T.A.; YUSUF, Abdulazeez; Abdullahi A.The study was carried out to assess the properties of High-strength concrete made using Quarry dust as Fine aggregate. Preliminary tests were carried out on the aggregates to determine their suitability for use in High- strength concrete. The aggregates were well graded and other properties met the requirements of aggregates to be used for High-strength concrete. Superplasticizer and Rice husk were used as chemical and mineral additives to improve the workability and other properties of the concrete. Based on the properties of the aggregates, a mix ratio of 0.23:0.51:0.044:1.05:0.7:0.2, representing cement: fine aggregate: coarse aggregate: superplasticizer: water: rice husk was used. Concrete cubes of 100x100x100 mm were cast, cured and the 28-day compressive strength determined. An average 28-day compressive strength of 63 N/mm2 was obtained. This can be categorized as class I high strength concrete and is applicable in the construction of high rise buildings. The Study therefore concludes that quarry dust can be used as total replacement for fine river sand in high strength concrete production.Item Hygrothermal Effects of Partial Replacement of Coarse Aggregates with Palm Kernel Shell in Concrete Production(Nigeria Journal of Engineering and Applied Sciences, 2017-08-12) Abdullahi A.; Abubakar M.; Aminulai H. O; YUSUF, Abdulazeez; Alhaji B.Hygrothermal effects of partial replacement of coarse aggregates with Palm Kernel Shell (PKS) in concrete production were assessed. Preliminary tests were conducted on PKS to determine its suitability for use as aggregate in concrete production. Workability and Density of the fresh concrete were also determined. Cylinders of 100mm diameter by 50mm height were used to cast the concrete; these were cured for 28 days and tested for water absorption and sorptivity at different replacement levels of coarse aggregates with PKS. The sorptivity of concrete was found to increase with increase in PKS content, however, between 5-25% PKS content, lower sorptivity values than control were recorded. Water absorption of concrete also increased with increase in PKS content, PKS contents from 5-20% gave water absorptions below the control and at 25% replacement, a slightly higher value as compared to the control was recorded. From the results obtained, concrete with 5% PKS content was found to possess the best water absorption as well as sorptivity values. Such concrete adequately fits for use in areas where concrete water absorption and sorptivity are required to be kept at a very minimal level; such as in the construction of drainages and dams.