Civil Engineering

Permanent URI for this collectionhttp://197.211.34.35:4000/handle/123456789/74

Civil Engineering

Browse

Author: search.filters.author.Abubakar, MahmudSubject: search.filters.subject.Concrete

Search Results

Now showing 1 - 2 of 2
  • No Thumbnail Available
    Item
    Partial Replacement of Sand with Sawdust in Concrete Production
    (3rd Biennial Engineering Conference, Federal University of Technology, Minna, May, 2013, 2013) Abdullahi, A.; Abubakar, Mahmud; Afolayan, A.
    The rising costs of building construction in developing countries have been a source of concern to government and private developers. This study investigated the use of sawdust as partial replacement for fine aggregates in concrete production. Sawdust was used to replace fine aggregates from 0% to 50% in steps of 10%. Concrete cubes measuring 150 x 150 x 150mm were cast and their compressive strengths evaluated at 7, 14, 21 and 28 days. Increase in percentage of sawdust in concrete cubes led to a corresponding reduction in compressive strength values. From the results, the optimum sawdust content was obtained at 10% and its corresponding compressive strength at 28 days is 7.41 N/mm2 which falls within the characteristic strength of plain concrete (7 – 10 N/mm2). This concrete cannot be used for structural applications.
  • No Thumbnail Available
    Item
    EFFECTS OF IRON ORE TAILINGS (IOT) ON THE MECHANICAL PROPERTIES OF CONCRETE
    (Conference Proceedings, 1st Faculty of Engineering and Technology Conference (FETiCON 2023), Jun. 5 - 7, 2023, University of Ilorin, Nigeria, 2023) Balarabe, F.; Abubakar, Mahmud
    A lot of research has shown that iron ore tailings (IOT) is not only a source of pollutant but also has good pozzolanic properties. However, the behaviour of IOT concrete in service is yet to be fully reported. This research investigates the effect of IOT on the mechanical properties of concrete whose fine aggregates is partially replaced with IOT. Fine aggregates content in concrete of mix ratio 1:2:4 of 10 to 40% was replaced with IOT. Young’s modulus and Poisson ratio of the resulting concrete beams were determined by compression test. The results showed that 20% replacement of fine aggregates by IOT in the concrete mix gave the best mechanical properties of the resulting concrete. The Young’s modulus of the concrete was seen to increase by 26.53% when with 20% IOT content when compared to that without IOT. The Poisson ratio at 20% IOT content was seen to also decrease by 61.54% when compared to that without IOT. As such, 20% IOT for fine aggregate content replacement in concrete mix 1:2:4 is recommended for structural uses.